Occasionally there may be power interruptions due to thunderstorms or other causes. Remove the power cord
from AC outlet when a power outage occurs. When power has been restored, replug power cord to AC outlet.
The unit will revert to the factory setting of 46ºF after any power outage. Reset your temperature selection.
Vacation and Moving Care
For long vacations or absences, empty contents from beverage and wine center, unplug the unit and clean the
beverage and wine center and door gaskets according to “General cleaning” section. Prop doors open, so air
can circulate inside. When moving, always move the beverage and wine center vertically. Do not move with the
unit lying down. Possible damage to the sealed system could occur.
Troubleshooting
Control Panel does not respond
Check if control panel is on.
Beverage And Wine Center Does Not Operate
Check if beverage and wine center is plugged in.
Check if there is power at the ac outlet, by checking the circuit breaker.
Check if power pad is on.
Temperature appears too warm
Frequent door openings.
Allow time for recently added beverages to reach proper temperature.
Check gaskets for proper seal.
Adjust temperature control to cooler setting
Temperature is too cold
If temperature control setting is too cold, adjust to a warmer setting and allow several hours for temperature to
adjust.
Beverage And Wine Center runs too frequently
This may be normal to maintain constant temperature during high temperature and humid days.
Doors may have been opened frequently or for an extended period of time.
Check gasket for proper seal.
Check to see if doors are completely closed.
Moisture build up on interior or exterior of the beverage center
This is normal during high humidity periods.
Prolonged or frequent door openings.
Check door gaskets for proper seal.
Beverage And Wine Center door does not shut properly
Level the beverage and wine center.
Check for blockages.
To Next Page
Loading...
Need help?
General
