Priming the water supply system
For proper dispenser operation, recommended water
supply pressure should fall between 30 psi and 100 psi.
Excessive pressure may cause water filter
to malfunction.
1
2
3
Begin filling the tank by pressing and holding a
drinking glass against the water dispenser paddle.
Keep the glass in I
this position until ....
water comes out
of the dispenser.
It may take
about
11/2 minutes,
Continue
dispensing water
for about four
minutes to flush
the system and
plumbing connections of any impurities (stopping to
empty the glass as necessary).
Turning the fresh food ice maker on and off
Ice production is controlled by the ice maker's On/Off
icon on the control panel. Press and hold the "Ice Off"
icon for three seconds to turn the ice maker "ON" or
"OFF". The ice maker is turned off when the LED above
the "Ice Off" icon is illuminated.
Turning off the ice maker will disable the ice dispenser.
The ice maker also has a built-in plastic signal bale arm
that automatically stops ice production when the ice bin
is full. This signal arm should not be used to manually
stop the ice maker.
Using the ice maker after installation
Before making ice for the first time, be sure to prime the
water supply system. Air in new plumbing lines can result
in two or three empty ice maker cycles. Furthermore,
if the system is not flushed, the first ice cubes may be
discolored or have an odd flavor,
The water dispenser has a built-in device that shuts off the
water flow after three minutes of continuous use. To reset
this shutoff device, simply release the disPenser paddle:.....................
Dispensed water is chilled. For colder water, add ice to
cup or container before dispensing water.
Ice maker operation & care
After the refrigerator is installed properly and has cooled
for several hours, the ice maker can produce ice within
24 hours. The ice maker will f!ll the ice bin from the rear.
You must dispense some ice to force the ice forward in
the bin. This will allow the bin to fill completely.
On occasion, unusually small ice cubes may be noticed
in the bucket or in dispensed ice. This could occur in
normal operation of the ice maker. If you start seeing
these more frequently, it may be an indication of low
water pressure or the water filter needs to be replaced.
As the water filter nears the end of its useful life and
becomes cloggedwith particles, less water is delivered
to the ice maker during each cycle. Remember, if it's
been six months or longer since you last changed your
water filter, replace the water filter with a new one. Poor
quality household water may require the filter to be
....changed more frequently, ..................................................................................................................................................................................................
Your ice maker is turned on at the factory so it can work
as soon as you installyour refrigerator. If you cannot
connect a water supply, set the ice maker's On/Off icon
to Off and turn off the water supply valve; otherwise,
the ice maker's fill valve may make a loud chattering
noise when it attempts to operate without water.........................................................
To Next Page
Loading...
Need help?
General
