11
EN
Installation notes
Selecting wall
plugs and screws
IMPORTANT!
Different fixings may be required to fit the mounting bracket depending on the type
of underlying surface.
Fixings are therefore not included in the scope of supply of the inverter. The installer is re-
sponsible for selecting the right type of fixing.
Recommended
screws
To install the inverter, the manufacturer recommends the use of steel or aluminium screws
with a diameter of 6 - 8 mm.
Fitting the wall
bracket
When mounting the wall bracket, ensure that the wall bracket is not warped or deformed.
Installing the in-
verter on a mast
Example of a mast fixing kit
When mounting the inverter on a mast or a
vertical carrier, Fronius recommends the
use of a standard mast fixing kit.
This kit enables the inverter to be mounted
on round or rectangular masts with various
cross-sections.
Fronius Primo
Installation Help
?
To Next Page
Loading...
Need help?
General