Fryette Power Station PS 2A User Manual

10
TROUBLESHOOTING GUIDE
SPECIFICATIONS
WON’TTURNON
1. Make sure AC cord is securely connected at
both ends.
2. Verify the power source with something you
know works.
3. Check the mains fuse, and replace if necessary.
If it blows again, refer to qualied service personnel.
NO SOUND
1. Check input cable.
2. Check volume controls.
3. Make sure the amplier volume and/or gain
controls are turned up.
4. Check to see if the e󰀨ects loop is connected
correctly.
5. Check speaker cable to see if it is disconnected
or shorted.
6. Make sure that the impedance selector is fully
engaged in its detent.
7. Check the standby switch.
8. Check for a blown speaker.
9. Check the mains fuse, and replace if necessary.
If it blows again, refer to qualied service personnel.
WON’TSWITCHTOOPERATE
1. Check the mains fuse, and replace if neces-
sary. If it blows again, refer to qualied service
personnel.
EFFECTS NOT OPERATING
1. Make sure e󰀨ects send and return cables are
good and properly connected.
RUNNING HOT
1. Make sure that the unit has adequate ventilation.
2. Make sure that the impedance selector is set to
the proper impedance.
3. Power tubes may be drawing excessive current
(refer to qualied service personnel).
NOTE: Always set the amplier to standby when
taking breaks and turn the amplier o󰀨 when
not in use. This will extend tube life and improve
long term reliability.
DISTORTION
1. Check the impedance setting.
2. Check the speaker cable for shorts.
3. Check the speaker.
4. Check the signal level at other devices in the
signal path or in the loop.
5. Power tubes may be weak (refer to qualied
service personnel).
BLOWING MAINS FUSE
1. Bad power tube or other internal power supply
component (refer to qualied service personnel).
MODEL: POWER STATION
MODEL NUMBER: PS2.
POWER REQUIREMENT: 180W
POWER AMP OUTPUT: 50W RMS @ 5% THD,
1kHz sine into 8Ω
INPUT IMPEDANCE: 2/4Ω/8Ω/16Ω (selectable)
OUTPUT IMPEDANCE: 2/4Ω/8Ω/16Ω (selectable)
FUSE:
100V UNITS: T3.15A, 125/250V.
120V UNITS: T3A, 250V.
220V-240V UNITS: T1.6A, 250V.
DIMENSIONS:
HEIGHT: 3.6 in (9.1 cm)
WIDTH: 14 in (35.5 cm)
DEPTH: 9 in (22.8 cm)
WEIGHT: 15 lb (6.8 kg)
Product specications are subject to change without notice.

Fryette Power Station PS 2A Specifications

General

Brand	Fryette
Model	Power Station PS 2A
Category	Amplifier
Language	English