Fuji Electric FVR2.2AS1S-7 User Manual

10.1 Conformity to the Low Voltage Directive in the EU (Continued)
To prevent the risk of hazardous accidents that could be caused by damage of the inverter, install the
specified fuses in the supply side (primary side) according to the following tables.
- Breaking capacity: Min. 10 kA
- Rated voltage: Min. 500 V
Power
supply
voltage
Appli-
cable
motor
rating
(kW)
Inverter type
Rated
Current(A)
of MCCB
(w/o DCR)
Three-
phase
400V
0.4
FVR0.4AS1S- 4
6
0.75
FVR0.75AS1S -4
1.5
FVR1.5AS1S -4
10
2.2
FVR2.2AS1S -4
15
3.7
FVR3.7AS1S -4
20
Single-
phase
200V
0.4
FVR0.4AS1S -7
10
0.75
FVR0.75AS1S -7
15
1.5
FVR1.5AS1S -7
20
2.2
FVR2.2AS1S -7
35
10.2 Conformity with UL standards and cUL-listed for Canada
UL/cUL-listed inverters are subject to the regulations set forth by the UL standards and CSA standards
(cUL-listed
for Canada) by installation within precautions listed below.
Integral solid state short circuit protection does not provide branch circuit protection. Branch circuit
protection must be provided in accordance with the National Electrical Code and any additional local
codes.
1. Solid state motor overload protection (motor protection by electronic thermal overload relay) is
provided in each model.
Adjust function codes F10 to F12 and H89 to set the protection level.
2. Connect the power supply satisfying the characteristics shown in the table below as an input power
supply of the inverter. (Short circuit rating)
3. Use 75°C
(167°F) Cu wire only.
4. Use Class 1 wire only for control circuits.
22

Fuji Electric FVR2.2AS1S-7 Specifications

General

Brand	Fuji Electric
Model	FVR2.2AS1S-7
Category	Inverter
Language	English