2 Paper and Other Media
66
Paper and Other Media
2
Note • When using punched paper, load the
punched paper as shown in the illustration on
the right.
3 Adjust the paper guides to align the edges of
the paper loaded.
Note • Entering the paper size is needed to use non-
standard size paper for copying using Tray 5.
You can assign the desired paper size to
[Standard Size] on the [Tray 5] screen if you
frequently use non-standard size for copying.
For information on how to assign the paper
size, refer to "Tray 5 - Paper Size Defaults"
(P.172).
4 Instruct a copy or print job.
Loading Paper in Tray 6 (HCF B1) (Optional)
The following describes the procedure for loading paper into Tray 6 (HCF B1) (optional).
When the machine runs out of paper during copying or printing, a message is displayed on
the touch screen. Add paper according to the displayed instructions. Copying or printing is
automatically resumed when paper is added.
Note • Carefully fan the paper before loading it in a tray. Otherwise, the paper may stick together, resulting
in paper jams.
For information on changing the paper size and orientation, refer to "Changing the Paper Size" (P.68).
1 Pull out Tray 6 until it stops.
Important • While the machine is processing a job, do not
pull out the tray that is being used for the job.
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add
paper on top of any remaining paper in the tray.
Make sure to pull out the tray slowly.
If the tray is pulled out with too much
force, the tray might possibly hit your
knees or other parts of your body and
cause injuries.
To Next Page
Loading...
Need help?
General
