Safety Notes
1-7
Do not incline the product more than 10 degrees.
When the machine is installed, be sure to lock the caster stoppers. An unlocked machine may fall
over or slide and cause injuries.
Always locate the output unit inside the rack under the scanning unit.
Others
In order to use and maintain this product in a good performance and condition, make sure to use the
product within the following environment:
•Temperature: 10~32°C
•Humidity: 15~85%
When the product is left in a freezing cold room and the room is rapidly warmed up by heater, it can
generate water drops inside the machine and cause a partial deletion on printing.
10°
10°
10°
10°
To Next Page
Loading...
Need help?
General
