6 - English Installing/removin g the
processor
Procedure
The processor socket is covered with a p ro tective cap to protect the spring
contacts. In the event of a warranty case , the mainboard can only be taken back
by F ujitsu Technology Solutions with the protective cap secured!
a
b
b
► Remove the heat sink.
► Press down the lever a nd unhook i t.
► Fold up the frame.
► Hold the processor between your thumb
and index finger and insert it into the socket
(b) so that the marking of the processor is
aligned with the marking on the socket (a).
► Press the lever downward until it is
hooked in again.
► Remove the prote ctive cap and keep it.
Please note that, depending on the heat sink used, different heat sink
mounts are req uired on the mainboard.
► Depending on t
he configuration variant, you must pull a protective foil off the heat sink
or coat the he
at sink with heat conducting paste before fitting it.
► Secure the heat sink - depending on the model - with four screws or push it into the mounts.
20 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General
