Fujitsu ETERNUS Connection Guide

ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris
9
Copyright 2010 FUJITSU LIMITED
P3AM-4562-01ENZ0
Chapter 3 Setting Up the Server
The server setup will vary according to how the ETERNUS Disk storage systems and server are
to be connected. Only Fabric connections are supported.
The Fibre Channel card Instance name, target WWN, and target ID information are necessary.
Check each item and enter them in the list. Edit the configuration file according to those informa-
tion and make settings.
Refer to the following to set.
• "3.1
Creating a WWN Instance Management Table for the Server" (page 9)
• "3.2 Setting Up Brocade Fibre Channel Cards" (page 12)
• "3.3 Setting the Configuration File (/etc/system)" (page 14)
3.1 Creating a WWN Instance Management Table for the
Server
Determine the following information for each Fibre Channel card installed in the server and enter
it into a copy of the "WWN instance management table for the server" (provided in "Appendix A
Management Table Template" (page 17)).
• Physical slot name
• WWN
• Number of the target controller connected to the Fibre Channel card
• Instance name
• Physical path name
WWN Instance Management Table for the Server
Procedure
1 Check the instance names.
"bfa + instance number" is the format used to represent Fibre Channel card instance
names.
Physical slot name
WWN
Instance
name
Physical path name
Controller
name

Fujitsu ETERNUS Specifications

General

Brand	Fujitsu
Model	ETERNUS
Category	Storage
Language	English