Troubleshooting and tips
The LCD screen is difficult to read
LCDscreenLCD screen
Cause Troublesho ot ing
Reflected glare ► Turn the notebook or alter the tilt of the LCD
screen.
► Increase the brightness of the screen.
The external monitor rem
ains blank
Monitor
Cause Troublesho ot ing
Monitor is switched off. ► Switch the external monitor on.
Power saving has be en activated (monitor is
blank).
► Press any key to continue.
Brightness is set to dark.
► Adjust the brightne
ss of the monitor.
Screen output is set to the notebook’s LCD
screen
► Press the key combi
nationtoswitchthe
screen output, see
"
Key com binations",
Page 24.
The external moni
tor’s power cable or data
cable is not conn
ected properly.
► Switch off the external monitor and the
notebook.
► Check whether the power cable is plugged
properly into the external monitor and into
the power socket.
► Check whether the data cable is properly
connected to the notebook and the external
monitor (if it is plugged in with a connector).
► Switch on the external monitor and the
notebook.
The external monitor is blank or the image is u nstable
ScreenMonitor
Cause Troublesho ot ing
The wrong external monitor has been selected
or the wrong screen resolution has been set for
the application program.
► Terminate the application program in
Windows by pressing
Alt
+
F4
.Ifthe
fault persists a fter closing the program, use
the key combination for switching the screen
output (see "
Key combinations", Page 24)to
switch over to the notebook’s LCD screen.
Change the following setting:
► Set the screen resolution: Set the screen
resolution as described in the do cume ntation
foryouroperatingsystem.
► Select monitor: Select monitor 1 or 2 as
described in the documentation for your
operating system.
60 Fujitsu
To Next Page
Loading...
Need help?
General