Operation
Selecting input signal (D-SUB/DVI-D/HDMI/DP)
► Touch the
INPUT
/ sensor to call up the Input select set tings window.
► Touch the
ECO
/ or the
INPUT
/ sensor to select the desired
monitor connection (VGA, DVI, HDMI or D P).
► Touch the
MENU
/ sensor to confirm your entries or the
AUTO
/ sensor to cancel the process.
This setting window can also be called up when the OSD menu is locked.
Locking the OSD menu
The OSD menu can be locked to prevent accidental or unauthorised changes to the monitor settings.
► Touch the
MENU
/ sensor for a few seconds while you switch on the
monitor using th e ON/OFF switch.
The message OSD locked / unlocked is displayed.
Please proceed in the same manner to release the locked OSD menu again.
Activate/deactivate ECO operating mode
The pow er consumption of the device can be decreased by reducing
the brightness of the picture.
► Touch t he
ECO
/
sensor to switch the ECO operating mode on or off.
The message ECO Mode on or ECO Mode off appears.
If the ECO
operating mode is activated, the following OSD settings are changed:
Mode
Office
Colour
6,500 K
Brightness
reduced
After the ECO operating m ode is switched off, the brightness previously set by the user is restored.
Fujitsu 21