RX1330 M1
Operating Manual 79
8 Troubleshooting and tips
V CAUTION!
Follow the safety instructions in the "Safety notes and regulations"
manual or " 安全上のご注意 " and in chapter "Important information" on
page 33.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the connected devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
8.1 Power-on indicator remains unlit
The power-on indicator remains dark after you switch on your device.
Power cable incorrectly connected
Ê Make sure that the power cable is correctly connected to the server and to
the power outlet on the rack's socket strip.
Power supply overloaded
Ê Disconnect the server power plug from the insulated socket.
Ê Wait a few seconds before you plug it into the insulated socket again.
Ê Switch on your server.
To Next Page
Loading...
Need help?
General