18
Maintenance
Oven rack guide:
The oven racks feature an anti-tip locking system.
To remove the racks push inside fully, then unclip the rear tabs from the locking
channel by pushing upwards and slide out.
To replace the racks slide the racks in fully, then push down on the back side to slip
the tabs into the anti-tip locking system.
Replacing the Oven Lamp
● Disconnect the oven from the 12V DC power supply by means of the switch or fuse.
● Unscrew the lamp-holder glass cover.
● Remove the lamp and replace high temperatures (300)
- Voltage: 12V
- Wattage: 15W
- Type G9
● Screw on the glass cover and reconnect the oven to the mains power supply.
How to replace the Control Knob LED (for models with LED
light only)
1. Disconnect the oven from the power supply by means of the switch used to
connect the appliance to the electrical mains, or unplug the appliance if the plug is
accessible.
2. Pull to remove the control knob with LED broken.
3. Remove the two screws holding the LED light using a Phillips screwdriver.
4. Pull to remove the socket connected to the LED.
5. Repeat steps 4 to 2 to replace the broken LED.
Step 1 Step 2 Step 3
To Next Page
Loading...
Need help?
General
