Furuno DFF1 User Manual

12
1.7.2 Thru-hull temperature sensor T-02MSB, T-03MSB
Select a suitable mounting location considering the following points:
• Select a mid-boat flat position. The sensor does not have to be installed perfectly
perpendicular. However, the location should not be such that the transducer may be
damaged when the boat is dry-docked.
• Locate away from equipment which gives off heat.
• Locate away from drain pipes.
• Select a location where vibration is minimal.
Assembling temperature sensor T-02MSB, T-03MSB
Sensor
Cable
Locknut
Washer
Rubber Gasket
φ21 mm
Apply sealant.
T-02MSB
Locknut
Locknut
Washer
Rubber Gasket
Apply sealant.
Thicker
than 25 mm
T-03MSB
Sensor Holder
Holder Guide

Furuno DFF1 Specifications

General

Brand	Furuno
Model	DFF1
Category	Marine Equipment
Language	English