20
3.5 SSAS Report Test
You can test for successful transmission of the SSAS report to the address you specify,
without using the button. The test report message states “!!! Test Call !!!” to alert the
receiver of the message that it is a test call.
Note: This function is only available in the SSAS manager mode. Switch to this mode (see
paragraph 3.1.2) and then follow this procedure.
1. Access the Report Destination Menu, referring to section 3.2.
2. Set destination where to transmit the test.
3. Press the [↑] key to choose Status and then press the [Enter] key.
4. Press the [↓] key to choose TEST and then press the [Enter] key.
5. Press the [Esc] key to open the Update window.
6. Yes is selected; press the [Enter] key. The test report is transmitted. After it is
transmitted, “Status” is automatically set to ON.
7. Press the [Esc] key twice to return to the standby display.
To Next Page
Loading...
Need help?
General
