NOTE: When you connect to a
stereo, all zones are selected
by default.
1
Press and to enter
zone selection mode.
The status LED begins
flashing green.
2
Press a button to make a
selection:
• Press for zone 1.
• Press for zone 2.
• Press for zone 3.
• Press for zone 4.
• Press for all zones.
• Press to cancel the
zone selection.
When a zone is selected
successfully, the status
LED turns on green briefly
and then turns off. When
zone selection fails, times
out, or is canceled, the
status LED turns on red
briefly and then turns off.
NOTE: When you select an
inactive or invalid zone, the
remote still functions but does
not control the volume. You
can select to select all
zones.
Replacing the Battery
The remote uses one CR2032
lithium coin-cell battery.
10 Instructions
To Next Page
Loading...
Need help?
General
