• 13 •
Blinking
• Switch the power button to “I” to turn
the machine on.
Circuit Priming
• To prime the water circuit, place a
container under the steam wand (Pan-
narello, if supplied).
• Make sure the selector switch is in the
“
” position; if this is not the case, set
it to that position.
• To turn the machine on simply press the
“STAND-BY” button.
• The blinking icons shown in the picture
warn that the circuit must be primed.
• The “STAND-BY” button blinks.
Blinking
Slow blinking
Cyclic blinking
Steady on
• Turn the selector switch clockwise to set
it to the “
” position. The machine
starts the automatic priming of the
circuit by letting out a preset quantity
of water through the Pannarello.
Once the circuit has been primed, the
icons shown in the gure will start to
blink.
Turn the selection knob back to its
central position “
”.
• The icons displayed blink slowly to
show that the machine is warming up.
When warm-up is complete,
the machine performs a rinse
cycle of the internal circuits.
During this phase, the icons displayed
will blink in sequence.
• When the operations described above
are completed, the icons on the display
will illuminate.
The display will appear as
shown to the side. The dis-
played aroma is the factory setting
when the machine is switch on for
the rst time, or it is the same as the
aroma that was selected for the last
brewed co ee.
The machine is then ready to brew
beverages.
• To brew co ee, dispense hot water or
steam, and properly use the machine,
carefully follow the instructions pro-
vided.
Note: Before starting the
machine for the first time,
and after long periods of inactivity,
prime the water circuit.
Note: This appliance has been
tested using co ee. Although
it has been thoroughly cleaned, some
coffee residues may still be found.
However, we guarantee that this is a
brand-new machine and we suggest
consulting the operating instructions
before starting up the machine.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
