Gardena 380 LI User Manual

19
GB
Cleaning the mower:
8. Maintenance
DANGER !
A
Cutting tool can cause injuries!
V When undertaking maintenance, remove the
safety key, wait for the cutting mechanism to
stop and put on suitable work gloves.
WARNING !
A
Damage to Accu cylinder mower.
V Never clean your cylinder mower with running
water, in particular with water under high
pressure.
Deposits affect the cutting result as well as discharge of grass
clippings. Residual dirt and grass is easily removed immediately
after mowing.
1. Remove grass deposits with a brush and a cloth.
2. Oil the red cutting mechanism lightly with low viscosity oil
(e.g. sprayed oil).
9. Troubleshooting
Danger of injury from the cutting tool!
V Before eliminating faults, wait until the cutting tool
stops, wear suitable work gloves and remove the
safety key.
Problem Possible cause Remedy
Abnormal noise. Screws / components loose. v Tighten screws or send
Clattering in the mower to GARDENA Service.
Foreign bodies on the blade. v Remove foreign bodies.
Notch in the blade. v Remove notches with
grindstone.
Blades are striking each other v Adjust cutting mechanism.
too hard.
Motor does not start Safety key not inserted. v Insert safety key.
Accu not correctly fitted. v Insert Accu until it locks in
place.
Discharging Accu. v Charge Accu.
Red Error LED is lit v Contact Gardena Service.
(Electronic or temperature
monitoring system defective).
Motor is blocked and Red Error LED flashes 1. Switch mower off.
hums (Mower overloaded, e.g. 2. Remove safety key.
due to blocked spindle). 3. Remove foreign body.
Cutting load too high. v Reduce mowing speed
and / or increase cutting
height.
DANGER !

Gardena 380 LI Specifications

General

Type	Push lawn mower
Cutting width	380 mm
Cutting height	42 mm
Cutting system	Cylinder blades
Ergonomic handle	Yes
Recommended lawn area	400 m²
Minimum cutting height	12 mm
Grass collecting volume	- L
Power source	Battery
Battery voltage	25 V
Battery capacity	3.2 Ah

Weight and Dimensions

Weight	14000 g