nüvi 2200/2300/2400 Series Owner’s Manual 61
Appendix
4. Place the silver tip in the end
piece.
5. Screw the end piece back into the
vehicle power cable.
Mounting on Your
Dashboard
Notice
The permanent mounting adhesive is
extremely difcult to remove after it
is installed.
Use the enclosed mounting disk to
mount your device to the dashboard
and comply with certain state
regulations.
1. Clean and dry the dashboard
where you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the
disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover
from the top of the disk.
5. Place the suction cup mount on
top of the disk.
6. Flip the lever down (toward the
disk).
Removing the Device,
Cradle, and Mount
Removing the Device from
the Cradle
1. Press up on the tab on the top of
the cradle.
2. Tilt the device forward.
To Next Page
Loading...
Need help?
General
