32
Advanced Settings Screen
kW
kW
FLASHING
50/60 Hz
FLASHING
ok
ok
or
Hz
ok
or
or
PHASE
or
ok
VOLTS
SOFTWARE
Version Displayed
VOLTS
FLASHING
SINGLE
or
THREE
FLASHING
or
ok
E-Governor
Check
Stepper Motor
will sweep through throttle
range for dealer
visual verification
“ADVANCED SETTINGS”
WILL SCROLL
or
or
ok
or
or
ok
or
or
ok
or
or
ok
or
or
ok
or
or
ok
Advanced setting parameters are preset at the factory for a typical installation. To view Advanced Settings items and/or to
change items, follow the instructions listed below.
NOTICE Advanced settings are critical to the operation of the unit. Careful consideration should be taken when working
in the Advanced Settings menu. Exercise caution when selecting and verifying parameters for the generator and region
where the generator is being operated. Confirm all settings before operating the generator for the first time.
For advanced menu items, press and hold the left arrow, right arrow, and escape key
for 3 seconds or see pg. 29
for additional key sequence. Follow the prompts as outlined below.
NOTICE In the Advanced Setting menu, a three button access code (left arrow, right arrow, and escape key
must
be pressed once to enter the menu and again to change any setting. After each confirmation of a setting, the selection will
display solid for 2 seconds before moving to the next program item.
*ONLY APPLICABLE ON SOME MODELS
*
To Next Page
Loading...
Need help?
General
