7
3. Connect the small end of the power supply into the POWER 9V AC jack
on the back of the answerer. Plug the other end into an AC power outlet.
The unit announces “please wait for the beep.” The unit pauses while
the MESSAGE indicator flashes and then beeps again when it is ready
for setup or to answer calls with the default greeting and settings.
CAUTION: Only use the ATLINKS USA, Inc. 5-2434 power supply that
was packed with this unit. Using other power supplies may damage the
unit.
IMPORTANT INSTRUCTIONS FOR MOVING THE ANSWERER:
To move the answerer to a different location in the house, follow these
instructions:
1. Disconnect the phone line or any phones you may have connected to
the unit.
2. Install a battery, if you have not already done so. This will ensure that
your messages are not lost. See “Installing the Battery.”
3. Go to the electrical outlet and unplug the power supply.
4. Move the unit and phone line to the desired location.
5. Plug the power supply into an electrical outlet.
6. The MESSAGES indicator flashes slowly if there is a new message.
7. Connect all necessary phone lines.
To Next Page
Loading...
Need help?
General
