Installation Instructions
REPLACING AN EXISTING UNIT?
Check the "Essential
Elements" label for
impotlant information.
Use the correct wallcase
This unit is designed to be installed in a GE plasti( or
insulaled melal x_v_llcase. This minimizes condensation
Iron1 fornfing Oll the room sid( of the case.
lithe ctlrl-tqlt wall (:as( is not insulated, 7,'ou can reduce
the possibili V ot cond( llSadon tbnning by installing
insulation kit I_\Kg0IL, a_dlable whel*! you purchased
th( unit.
NOTE: There are several extra boles in tbe unit side
t]angcs tbr installation in wall cases otber than C,1L
"I'o avoid damaging tile flange insulation, the installer
should use an awl or other sharp tool to puncture tbe
insulation in the apl)ropriate holes l)etbre installing
th_ attachment screws.
Use the correct outdoor ,grille
You should use tbe outdoor grilh's shown oll the
"Essential Elements" label on the top of lbe tlllil.
• If an existing grille is not replaced, capacit} and
et_ci( ncy will b( reduced and tbe tlllit may thil to
operate properly or t5il l)remanlrel); A deflector kit,
l_\K40, may be used with grilles that were not
designed tot your new GE Zonelines. The I_YK40
eonlains air detlector_ and gaskels that re(mat to the
unit to dirt ct the hot exbaust air away from tbe air
inmk( to allow the unit to function properl). The
grille nlust have a 65_ minimum fi'ee area.
• Any v_rtical deflectol.-s ill the existing rear grille sh(afld
be 1-( llloved 1o decrease ColldellseF air l-t,Cilclllalioll
that can cause the unit to "short-cycle" and lead
tO l)l-elnalllre colnpoll( lit thihlre.
Use the correct power cord
Lo(al (o(Ics may rcquirc tim use of at( th!lh or
leakage current detection devices on 230/208 volt
installations.
Replacing a ducted unit
New ducted installation:
It tiffs trait is to bc installed in a ll('W ductcd application
using a duct adapter kit, the kit must be installed befbre
the unit is pla_ ed in the wall (:as(. The installation
instructions are packed witb the kit.
#ate
Existhlg ducted installation:
Replacement of an existing ducted unit may rcqub-e
difli..rent (onq)onent',. Request this intbHnation fl-om
_k)lll" sales l-e[)Feseiltative.
• Replacing 230/208 volt traits:
See page 14.
• Replachlg 265 volt traits:
See pages 15 and 16.
13
To Next Page
Loading...
Need help?
General
