Installation Instructions
230/208 VOLT ELECTRICAL CONNECTION OPTIONS
HOW TO CONNECT
1 Remoxe the room cabinet.
2 Corm(el to electrical powel;
3 Review the following steps fin appli(able supply
voltages.
4 Reinstall the room cabin(t.
Power cords may include an arc fault interruption or
a leakage current detection interruption device. A
test and reset button is provided on the plug case or
the iuline case. The device should be tested on a
periodic basis by first pressing tile TEST button and
then the RESET button. If the TEST button does
not trip or if the RESET button will not stay engaged,
discontinue use of the Zoneline and contact a
quMified service technician.
POWER CORD
CONNECTION
A power supply kit must be used 1o supply power to the
/xmeline unit. The apl_ropliam kit isdetelmined by the
xoltage, tile re(arts el electrical connection and tile
amperage of tile branch circuit.
Power supply kit
(_onneclions of 208 or 230 volt drcuils nmv be wilh a
power supply kil or ajunction box kit.
All wiring, inchlding installation of th( receptacle,
must be in accordance with the NE( and local codes,
ordinan(es and regulations. Local (odes ma 3 require
the use ot an arc fault or leakage current det(ction
device on the power cord. Be sure to select the
correct cord fk_r your installation.
©©@
Tandem Perpendicular Large Tandem
15Amp 20Amp. 30Amp
230/208volt receptacle configuration,
Branch Circuit and Proper GE Power Cord
Unit Amperage Rating with LCDI Device
15 K\_lS!;
20 1_\K'_203
30 K\I_3(}3"
*No1 apprmed fi)r/ise on 7000 BTI J models.
14
ELECTRICAL SUBBASE
CONNECTION
9 _ /9
_ 0, _(}S xoh nod(Is may b( install(d using on¢ ot
the following electrical subhases:
Branch Circuit and Proper GE
Unit Amperage Rating Subbase Kit
15 l_kIg204D 151'
20 I_YK2(}4I)20P
30 I_YK2(I4D3(IP*
*Nol approved fbt list"(m 7000 Bq_J models.
El(ctrical subbas( s l)rovid( an ( nclosure for (lir( cl
(Olllle([ioll or ( ll(los(d recel)ta(l¢s. The sul)l)as¢ kit
indu&s the pow(r (ord.
The instluctions provided with the s(lecmd subbase kit
must be carefull) tbllo_ed. It is th( responsibility ot tile
installer to ellSllre the COllllection of coIllDonellty, is
done in acco_xlance with these instructions and all
( lectrical codes.
DIRECT CONNECTION
Ord(r th( foll,.)wing Kil for 2 0/208 x )h d _(t
connection as required:
BranchCircuitand PowerSupply Power
UnitAmperageRating Accessory SupplyKit
17> l_\K4002A I_YK4157
20 ]_\K4002A 1_kK42()7
30 I_:\K40(}2A R:'vK43(}7
Skip to lh{ "MAKE EI_ECI'RIC.\[_C()NNECTION TO
TI IE,t NrI'" section.
To Next Page
Loading...
Need help?
General
