GE Concord 4 User Manual

GE Concord 4 Quick User Guide Page 2
Disarm the System
• Dis
arming - Press the Disarm button and follow prompt to “ENTER CODE”.
Arming & Disarming the System
Level 1 – Off
Use this level to:
• Cancel an alarm and stop sirens.
• Disarm the system when entering the armed premises. (Entry beeps sound to
remind you the system is armed and you must disarm it.)
• Disarm the system before opening a door/window while the system is armed.
1. Press 1. The keypad will display “ENTER CODE”.
2. Enter your access code. The keypad will display the date & time or programmed text and
the system will sound one long beep.
Level 2 – Stay
Use this level to:
• Arm perimeter doors and windows only.
1. Close all protected doors and windows.
2. Press 2. The keypad will display “ENTER CODE”.
3. Enter your access code. The keypad will display “Armed to Stay” and the system will
sound two short beeps.
Level 3 – Away
Use this level to:
• Arm perimeter door and window sensors and interior motion sensors for maximum
protection.
1. Close all protected doors and windows.
2. Press 3. The keypad will display “ENTER CODE”.
3. Enter your access code. The keypad will display “Armed to Away” and the system will
sound three short beeps.
4. Exit through designated door immediately.
Note: If you arm your system in AWAY mode, but do not open and close a door, the system will
automatically change to STAY mode to prevent a false alarm.
Before Calling…
♦ Is the keypad beeping? Press *. This will silence the beeping and let you
know
where the trouble is.
♦ Is there a flashing * on the keypad? Press * for status information.
♦ Is there a P1 on the display? This means Partition 1 and is not a trouble.
This is standard on ALL systems.
♦ Is siren going off? ENTER CODE to stop siren.

GE Concord 4 Specifications

General

Brand	GE
Model	Concord 4
Category	Security System
Language	English