GE DCL333 User Manual

Preparingtoinstallyourdryer.
Read these instructions completely and carefully.
&
WARNING
• This dryer must be exhausted to the outdoors.
Use only rigid metal or flexible metal 4"
diameter ductwork for exhausting m the
outside. Use only rigid metal 4" diameter
ductwork inside the dryer cabinet.
• The National Fuel Gas code restricts installations
of gas appliances in garages. They must be 18"
(45.7 cm) off the ground and protected from
vehicles by a barrien See Location of Your Dryer
section.
• Neveruse plastic orother combustibleductwork.
See Exhaustingsection.
• This appliance must be properly grounded
and installed as described in these Installation
Instructions.
• Do not install or store appliance in an area
where it will be exposed to ,a-ater/weathm:
See Location of YourOryersection.
• The electricalservice to the dryer must
conform with local codes and ordinances and
the latest edition of the National Electrical
Code, ANSI/NFPA 70.
• The gas service to the dryer must conform with
local codes and ordinances or the latest edition
of the National Fuel Gas Code ANSI Z223.1.
The gas dryer is designed under ANSI Z 21.5.1
for home use only. This dryer is not
recommended for commercial applications
such as restaurants or beauty salons, etc.
ToolsandMaterialsRequiredforDryerInstallation
[] Phillips head screwdriver
[] Adjustable pliers
[] Carpenter's level
[] Flat or straight blade screwdriver
[] Duct tape
[] Rigid or flexible metal 4" (10.2 cm) duct
[] Vent hood
[] Pipe thread sealer {GAS DRYER)
10
PreparingtheInstallationSiteandUnpackingtheDryer
[]Prepare the area and exhaust tor installation
of the new drym:
[]Check to be sure that the existing external
exhaust is clean and that it meets attached
installation specifications.
[]Using the tbur shipping carton corner posts
as padding (two on each side), caret_dly lay
the dryer on its let} side and remove foam
shipping pad.
CAUTION:To prevent damage,
do not use the control panel as a means
to pick up or move the dryen
_ Return the dryer to an upright position.
_Move the dryer to the desired location.
_ Connect the external exhaust.
[Adjust the leveling legs to match the washer
height. The dryer must be level and rest
firmly on all four leveling legs.
_ Connect the power supply.
Foamshippinggad
_ Check the operation of the power supply
and venting.
_ Place the Owner's Manual and the
Installation Instructions in a location where
they will be noticed by the owner.
Packing

GE DCL333 Specifications

General

Brand	GE
Model	DCL333
Category	Dryer
Language	English