GE EGR2000 User Manual

I
Installation Instructions
Range
If you have questions, call 1.800.GE.CARES or visit our Website at: GEAppliances.com
I
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber
or gas fitter.
• When using ball-type gas shut-off valves, they shall
be the T-handle type.
• A flexible gas connector, when used, must not exceed
3 feet.
BEFORE YOU BEGIN
Readthese instructions completely and carefully.
Installation of this range must conform with local
codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition. In Canada, installation must conform with
the current Natural Gas Installation Code, CAN/
CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition, and Canadian Gas Association according to
CAN/CGA-I.1 latest edition.
Aswith any appliance using gas and generating heat,
there are certain safety precautions you should follow.
You will find these precautions in the Important Safety
Information section in the front of this manual. Read
them carefully.
•IM PORTANT- Savetheseinstructions
for localelectrical inspector's use.
•IMPORTANT - Observeallgoverning codes
and ordinances.
• Note to Installer - Besure to leave these
instructions with the Consumer.
• Note to Consumer - Keepthese instructions
for future reference.
• Note - Thisappliance must be properly grounded.
• Servicer - Theelectrical diagram is in an envelope
attached to the back of the range.
• Skilllevel- Installation ofthis appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
PART INCLUDED
Anti-Tipbracketkit
33
FOR YOUR SAFETY
Donot store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of this
or any other appliance.
Ifyou smell gas:
O Open windows.
Don'ttouch electricalswitches.
Extinguishany open flame.
Immediately callyour gas supplier.
TOOLS YOU WILL NEED
Phillips screwdriver
Flat-bladescrewdriver
_ -cS_" .....................................
Penciland ruler
Pipewrenches(2)
(onefor backup)
Open-end or
adJustable wrench
Level
Drill, awl or nail
MATERIALS YOU MAY NEED
• Gasline shut-off valve.
• Pipe-jointsealant or UL-approved pipe thread tape with
Teflon*that resistsaction of natural and LPgases.
• Flexiblemetal appliance connector (1/2" I.D.)A g-foot
length is recommended for ease of installation but other
lengths are acceptable. Neveruse an old connector
when installing a new range.
• Flareunion adapter for connection to gas supply line
(3/4" or 1/2" NPTx 1/2" I.D.)
• Flareunion adapter for connection to pressure regulator
on range (1/2" NPTx 1/2" I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 112" O.D.sleeve anchor (for concrete floors
only).
*Teflon: Registeredtrademark of DuPont

GE EGR2000 Specifications

General

Brand	GE
Model	EGR2000
Category	Ranges
Language	English