Troubleshooting
Tips
-
Handle Installation
Handle too hard b
instrlUHandle tequircs
excesive torce to
itlr;fg, l
Mormting
bolts too tight- Remove
the handle.
Loosen the mounting
bola
sltghtly so that the handle will
snap
into place
when installed.
Defective normting bracket
or
bolts.
Remove
handle.
Check for defective
mounting
brackets or bols. If defective, replace.
Install
handle according to Installation
Instructions.
Larce handle/l{andle
rmkes
ratiling noise
at
fficlnretrt
Loose
normtingbolts
If the
handle installs properly
(slides
on and
locks/snaps into place)
but
is
loose, remove the
handle and tighten the mounting
bola. Use
a
lomm
socket
and ratchet
or wrench. Do not use a
screwdriver as
it will
not provide
enough torque
for
proper tightening.
Reinstall handle
according
to Insrallation Instructions included wi&
the
handle.
Freezer
handle is installed
baclmtards.
Remove handle.
Check for correct mounting
brackets
on
the
handle. There is
a right bracket
(R)
and a left bracket
(L).
The
handle has the
word
'RIGHT"
printed
in the bracket
cavity.
The
"R'bracket
should
be
installed in
the bracket
cavity marked
"RIGI{T".
The
"L"
bracket should
be
insr^lled on the
opposite side. Reinstall handle
according
to
Installation Instructions.
Fresh Foodhandle is mormtedupside
dorrn
or
incorrectly
relative to the
curve
ofthe Fresh Food door.
Make certain that the arrow label
on the
handle
is pointing at the center
of
the
unit. To
veri$,
the
handle should
look
straight from a
distance
(not
slanted to the side).
-5-
To Next Page
Loading...
Need help?
General
