GE GDT645SYNFS User Manual

Dishwasher Installation
LITERATURE
• Be sure to leave complete literature package, these Installation
Instructions and product samples and/or coupons with the
consumer.
REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
• Align the toekick with the bottom edge and make
sure it is against the floor.
• Insert and tighten the 2 toekick attachment screws.
The toekick should stay in contact with the floor.
Tip: Reduce sound from under the dishwasher.
Make sure toekick is against floor.
Figure AJ
Attachment
Screws
Toekick
CHECK THE FOLLOWING
• Tub trim does not interfere with the door
• Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door
• On models without the adjustable leveling system,
make sure all 4 legs of the dishwasher are firmly in
contact with the floor
• On models with the adjustable leveling system, make
sure both front legs of the dishwasher and the center
rear leveling system leg are firmly in contact with the
floor
• Drain hose is not pinched between the dishwasher
and adjacent cabinets or walls
• Tub trim is fully seated on the tub flange
STEP 22
STEP 23
STEP 24
15

GE GDT645SYNFS Specifications

General

Style	built in
Color	stainless steel
Load Capacity	up to 16 place settings; 16 place settings
Number of Cycles	5 (heavy wash, normal wash, light wash, 1 hour wash, rinse)
Number of Options	11
Drying Type	heated & vented
Noise level	48 dba
Control Type	front controls, 8 touch pads; touchpad
Delay Start	yes
Spray Arms	3 wash levels (lower, middle, upper)
Dispenser	rinse aid dispenser with indicator and adjustment
Water Filter	yes
Leak Protection	yes
Water Softener	no
Food Disposer	yes
Sanitize Settings	yes
Wi-Fi	no
Smart Home	no
Remote Control	no
Voltage	120 volts
Current	15

Weight and Dimensions

Depth	24 inch
Height	34 5/8 inch
Width	23 3/4 inch