6
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Using the surface units.
Be sure you turn the control knob to
OFF when you finish cooking.
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both OFF and MAX the control clicks
into position. You may hear slight clicking
sounds during cooking, indicating the
control is keeping the power level you set.
A surface unit ON indicator light will
glow when any surface unit is on.
WARNING: The surface
units are automatically disabled during
the self-clean cycle. Make sure that all
surface unit controls are turned off at all
times during the self-clean cycle. Any
surface unit that is set to an on position,
while the self-clean cycle is operating, will
automatically come on after the self-clean
cycle is finished, and could result in an
on, unattended surface unit. Wait until
the self-clean cycle is finished to set and
use the surface units.
To Next Page
Loading...
Need help?
General
