Cleaning the glass cooktop.
12
Safety Instructions
Operating Instructions
Care and CleaningTroubleshooting TipsConsumer Support
Sugary spillovers (such as
jellies, fudge, candy, syrups)
or melted plastics can cause
pitting of the surface of your
cooktop (not covered by the
warranty) unless the spill
is removed while still hot.
Special care should be
taken when removing hot
substances.
Be sure to use a new, sharp
razor scraper.
Do not use a dull or nicked
blade.
Be careful not to slide pots and pans
across your cooktop. It will leave
metal markings on the cooktop
surface.
These marks are removable using
the Ceramic Cooktop Cleaner with
the Cleaning Pad for Ceramic
Cooktops.
If pots with a thin overlay of
aluminum or copper are allowed
to boil dry, the overlay may leave
black discoloration on the cooktop.
This should be removed
immediately before heating again
or the discoloration may be
permanent.
WARNING: Carefully check the
bottom of pans for roughness that would scratch
the cooktop.
Metal Marks and Scratches
Glass surface—potential for permanent damage.
Damage from Sugary Spills and Melted Plastic
Turn off all surface units. Remove
hot pans.
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper to move the spill to
a cool area on the cooktop.
b. Remove the spill with paper
towels.
Any remaining spillover should be
left until the surface of the cooktop
has cooled.
Don’t use the surface units again
until all of the residue has been
completely removed.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop glass
will have to be replaced. In this case, service will
be necessary.
To inquire about purchasing a part or
an accessory for your appliance, please
call our toll-free number:
National Parts Center 1.800.661.1616
www.GEAppliances.ca
Ceramic Cooktop Cleaner . . .# WX10X300
Ceramic Cooktop Scraper . . .# WX10X302
Kit . . . . . . . . . . . . . . . . . . . . . . . .# WB64X5027
(Kit includes cream and cooktop scraper)
Cleaning Pads for
Ceramic Cooktops . . . . . . . . .# WX10X350
To Order Parts
To Next Page
Loading...
Need help?
General
