Installation Instructions
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
The air a(!iustnlent shutter fin" tile top (broil) burner is
in the center of the rear wall of the oxen.
Jstment
shutter
The shutter fin" the botton/ (oxen) bm'ner is near the
back wall behind the warming drawer. Remoxe the
drawer. See the Care and cleaning of the range section.
To adjust the flow of air to either burner, loosen the
Phillips head screw and rotate the shutter toward open
or closed position as needed.
The flames for the top (broil) burner should be stea(h
with approximately 1" blue cones and should not
extend out oxer the edges of the bm'ner battle.
To determine if the bottom burner flames are bm'ning
i)roperl):, remove the oven bottom. [qames should have
approximately l" blue cones and, if range is sui)plied
with natural gas, should bm'n with no yellow tipping.
(_A]th most I.P gas, small yellow tips at the end of outer
cones are normal.) Flames should not lilt ott bm'ner
ports. If lilting is observed, gradually reduce air shutter
opening until flames are stabilized.
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY (CONT.)
To remove the oven bottom:
A. Remove the screws holding down rear of the oven
bottolll.
B. (;rasp the oven bottom at finger slots on each side.
C. i,ift tile rear of the oven bottom enough to clear the
lip of the range frame, push it back, and then pull it
up and out.
[] LEVELING THE RANGE
A. Install the oven shelves in tile oven and position the
range where it will be installed.
Raise Lower
II Lower range range
range
range
(on some models) (on some models)
B. Check tot levelness by placing a spirit level or a cup,
partially filled with water, on one of the oven shelves.
If using a spirit level, take two readings--with the
level placed diagonally first in one direction and
then the other.
C.
D.
Remove the drawer. See the Care and cleaning of the
range section. The fl'ont leveling legs can be a(!justed
fl'om the bottom and the rear legs can be a(!justed
fl'om the top or the bottom.
Use an open-end or a(!iustable wrench to a(!iust the
lexelin,,_ legs until the ranoe_ is lexel.
E. After the range is level, slide tile range awax from the
wall so that the Anti-Tip dexice can be installed.
48
To Next Page
Loading...
Need help?
General
