Cleaningthe glasscooktop. .. .G pliances.cem
Control Lockout tonsomemodels)
Begin by locking the cooktop; see tile
ControlLockoutsection.
Cleanyourcooktopafter
eachspill. UseCERAMA
BRYTE®CeramicCooktop
Cleaner.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE®Ceramic
Cooktop Cleaner on tile glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
[]
Before using tile cooktop fbr tile
first time, clean it with CERAMA
BRYTE®Ceramic Cooktop Cleaner.
This helps protect tile top and
makes cleanup easier.
[] Daily use of CER_MMABRYTE®
Ceramic Cooktop Cleaner will help
keep tile cooktop looking new.
[]
[]
[]
Shake the cleaning cream well.
Apply a few drops of CERAMA
BRYTE®Ceramic Cooktop Cleaner
directly to the cooktop.
Use a paper towel or C£R_MMA
BRYrE ®Cleaning Pad for Ceramic
Cooktops to clean the entire
cooktop surface.
Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE:It is veryimportantthat youDONOT
heatthecooktopuntil it hasbeencleaned
thoroughlg
Use a CERAMA BRYTE®Cleaning
Pad for Ceramic Cooktops or a
Scotch-Brite 4°Multi-Purpose No
Scratch blue scrub pad.
Burned-On Residue
WARNING:DAMAGEto yourglasssurface
mayoccurif youusescrubpadsotherthanthe
pad includedwith yourcooktop.
[] Allow tile cooktop to cool.
[] Spread a few drops of CEP_MMA
BRYTE®Ceramic Cooktop Cleaner
on the entire burned residue area.
[] Using tile included CER_MMA
BRYTE ®Cleaning Pad for Ceramic
Cooktops, rub the residue area,
applying pressure as needed.
[] If any residue remains, repeat the
steps listed above as needed.
[] For additional protection, after all
residue has been removed, polish
the entire surface with CERAivb\
BRYTE®Ceramic Cooktop Cleaner
and a paper towel.
The CERAMABRYTB_ Ceramic
Cooktop Scraper and aft
recommended supplies are
available through our Parts Cente_
See instructions under "To Order
Parts" section on next page,
NOTE:Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
[] Allow tile cooktop to cool.
[] Use a single-edge razor blade
scraper at approximately a 45 °
angle against the glass surface
and scrape tile soil. It will be
necessary to apply pressure to
the razor scraper in order to
remove the residue.
[]
After scraping with the razor
scrapm; spread a few drops of
CER_MMABRYI'E®Ceramic
Cooktop Cleaner on tile entire
burned residue area. Use the
CER_MMABRYI'E®Cleaning Pad to
remove any remaining residue.
[]
For additional protection,
after all residue has been
removed, polish the entire
surface with CER_MMA BRYTE ®
Ceramic Cooktop Cleaner
and a paper towel.
25
To Next Page
Loading...
Need help?
General
