Usingthe clock, timer and controllockout. , OEA Ii,,co,oom
Make sore the clock is set to the
correct time of dag
ToSet the Clock
The clock must be set to the correct time
of day tor the automatic oven timing
flmctions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
[] Press the CLOCKpad.
[] Press the number pads.
[] Press the STARTpad.
The timer is a minute timer only.
The timer does not control oven
operations, Themaximum setting on
the timer is 9 hours and 59minutes,
To Set the Timer
[]
[]
Press the KITCHENTIMERON/OFF
pad.
Press the number pads until the
amount of time you want shows in
the display. For example, to set 2
hours and 45 minutes, press 2, 4
and 5 in tbat order.
If you make a mistake press the
KITCHENTIMERON/OFFpad and
begin again.
[] Press the STARTpad.
AfterpressingtheSTARTpad,SETdisappears;
thistellsyouthetimeiscountingdown,although
thedisplaydoesnotchangeuntiloneminutehas
passed.Secondswill not beshownin thedisplay
untilthelastminuteis countingdown.
[] When tbe timer reaches :00, tbe
control will beep 3 times followed
by one beep evm T 6 seconds until
the KITCHEN TIMER ON/OFF pad
is pressed.
The&secondtonecanbecanceledbyfollowing
thestepsin theSpecialfeaturesofyouroven
controlsectionunderTonesat theEndofa
timedCycle.
To Reset the Timer
If the display is still showing tbe time
remaining, you may change it by pressing
tile KITCHEN TIMER ON/OFF pad, then
press the number pads until the time you
want appears in tbe display.
Iftbe remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing tbe KITCHEN TIMER ON/OFF pad
and then pressing the number pads to
enter the new time you want.
To Cancel the Timer
Pressthe KITCHENTIMERON/OFFpad
_dce.
Control Lockout
Yourcontrolwill allowyouto lockout thepress
padssotheycannotbeactivatedwhenpressed.
To lock/unlock tbe controls:
[] Press the 9 and 0pads at the same
time for 3 seconds, until the display
shows LOCON.
[] To unlock tbe control, press the
9 and 0pads at the same time for
3 seconds, until tbe display shows
LOCOFF.
When tbis fi?ature is on and the press
pads are pressed, the control will beep
and the display will show LOCON.
N Thecontrollockoutmodeaffectsallpress
pads.Nopresspadswill workwhenthis
featureisactivated
N Theadjustmentwill beretainedinmemory
afterapowerfailure.
13