Attach the oven to the top cabinet.
18
Installation Instructions
3
2
Rotate front of oven up
against cabinet bottom.
1
MOUNT THE OVEN
B5.
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord tight.
Be careful not to pinch the cord, especially when
mounting flush to bottom of cabinet.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by
pulling cord.
Lift oven, tilt it
forward, and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
8
7
5
Cabinet Front
Cabinet Bottom Shelf
Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
Filler Block
Oven Top
Equivalent
to Depth
of Cabinet
Recess
Insert 2 self-aligning screws
(
1
⁄4″-28 x 3
1
⁄4″) through outer
top cabinet holes. Turn two
full turns on each screw.
Tighten center
screw completely.
Install grease filters. See the Owner’s Manual
packed with the oven.
Self-Aligning Screw
6
4
NOTE: Use self-aligning screw,
1
⁄4″-28 x 2
5
⁄8″, on
JVM1790 and self-aligning screws,
1
⁄4″-28 x 3
1
⁄4″,
on JVM1490, SCA1000, and SCA1001.
To Next Page
Loading...
Need help?
General
