GE JVM1630 Installation Instructions

11
Installation Instructions
ALIGNING THE MOUNTING PLATE
Draw a vertical line on the wall at the center of the 30″
wide space.
Use the mounting plate as the template for the rear wall.
Place the mounting plate on the wall, making sure that
the tabs are touching the bottom of the cabinet or
thelevellinedrawninStepCforcabinetswithfront
overhang.Lineupthenotchandcenterlineon
the mounting plate to the center line on the wall.
While holding the mounting plate with one hand, draw
circles on the wall at holes A, B, C, and D (see illustration
above/actual plate marked with arrows) . Four holes
must be used for mounting.
NOTE: Holes C and D are inside area E. If neither C nor D
is in a stud, find a stud somewhere in area E and draw a
fifth circle to line up with the stud. It is important to use
at least one wood screw mounted firmly in a stud
to support the weight of the microwave oven.
Set the mounting plate aside.
WARNING:Riskofelectricshock.Cancause
injuryordeath.Takecaretonotdrillintoelectricalwiring
inside walls or cabinets.
Drill holes on the circles. If there is a stud, drill a
3
⁄16″ hole
for wood screws. For holes that don’t line up with a stud,
drill a
5
⁄8″ hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
2
3
4
Draw a
Vertical Line
on Wall from
Center of Top
Cabinet
Area E
Hole A
Hole B
Hole D
Notch
Hole C
D
CAUTION:
Wearglovestoavoidcutting
fingers on sharp edges.
1
30”
1” = 2.5 cm; 1’ = 0.3 m

GE JVM1630 Specifications

General

Brand	GE
Model	JVM1630
Category	Microwave Oven
Language	English