LIGHT BULB REPLACEMENT
Cooktop Light
To replace the
combination
cooktop light/
night light, first
disconnect
power at main
fuse or circuit
breaker panel
or pull plug.
REMOVE SCREW
Remove screw on right side of light compartment
cover and lower cover until it stops.
Oe u e u, stobe!'
replaced are cool
before removing.
Break the adhesive __---=--- " = " "
seal by gently
unaoig_g_et _i_alI_ilb s.
Replace with 40-watt
incandescent bulbs (WB02X4253) available from your
GE supplier. High intensity 40-watt bulbs (40S 11N/1),
which are available in supermarkets and hardware
stores, may also be used for replacements. Raise light
compartment cover and replace screw. Connect
electrical power to microwave oven.
Oven Light
To replace your oven light, first
disconnect power at main fuse
or circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold
it in place
Next, remove the single screw
located above door near center
of oven that secures light housing.
Replace burned-out bulb with
a 40-watt incandescent bulb
(WB02X4253), available from
your GE supplier.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About I tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
43
To Next Page
Loading...
Need help?
General
