GE JVM2052 Installation Instructions

17
Installation Instructions
Attach the exhaust adapter to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
3
ADAPT MICROWAVE OVEN
BLOWER FOR OUTSIDE BACK
EXHAUST (cont.)
B4
7
WARNING: Risk of electric shock
can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wires
are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave oven.
Push in securely until it is in the lower locking
tabs. Take care to ensure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
Guide
Guide
Adapter
Locking Tabs
Back of
Microwave Oven
BEFORE: Fan Blade
Openings Facing Up
End B
End A
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
Rotate the unit so that the exhaust ports face
the rear of the cabinet. When you insert the blower
unit, the blower wire must be as shown.
Place the blower unit back into the cabinet.
Check that the exhaust ports face toward
the rear of the cabinet.
Exhaust ports
Blower unit
Exhaust ports
Back plate
Blower unit
mounting screw
(2 screws)
Blower plate
mounting screw
(3 screws)
Blower plate
Blower unit
Blower unit exhaust ports
4
5
Reattach the blower plate to the cabinet so
the exhaust ports and blower plate opening
are aligned. Attach with 2 blower unit mounting
screws and then 3 blower plate mounting screws.
6

GE JVM2052 Specifications

General

Brand	GE
Model	JVM2052
Category	Microwave Oven
Language	English