GE JVM2052 Installation Instructions

8
Installation Instructions
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16″ or 24″ from this mark.
Draw a line down the center of the studs.
IMPORTANT: The microwave oven must be connected
to at least one wall stud.
1
Remove the installation instructions, filters, glass tray
and the small hardware bag. Do not remove the
Styrofoam protecting the front of the oven.
Fold back all 4 carton flaps fully against carton sides.
Then carefully roll the oven and carton over onto the top
side. The oven should be resting in the Styrofoam.
REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
FINDING THE WALL STUDS
B
2
PLACEMENT OF THE MOUNTING PLATE
1
Wall
Studs
Center
3
Carton
Pull the carton up and off the oven.
Remove the 2 screws from the mounting plate. This
plate will be used as the rear wall template and for
mounting. You may discard these screws.
Mounting
Plate
Screws
2
Styrofoam
3
5
Remove and properly discard plastic bags.
4
1
A

GE JVM2052 Specifications

General

Brand	GE
Model	JVM2052
Category	Microwave Oven
Language	English