GE JVM3162 Installation Instructions

Attach the exhaust adaptor to the oven rear panel
by sliding it into the guides at the top
center of the back of the oven.
OUTSIDE BACK EXHAUST (Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Exhaust Adaptor to
Wall Plate
B3. Attach Mounting Plate
to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Oven
Installation Instructions
B
15
Unscrew and remove the exhaust adaptor
assembly from the top of the oven.
1
2
Exhaust Adaptor
Damper
(hinge side up)
Locking
Tabs
Guide
ATTACH THE EXHAUST ADAPTOR TO
THE OVEN REAR PANEL
B2.
Guide
Push in securely until it is in the lower locking tabs. Take
care to assure the damper hinge is installed so that it is
at the top and that the damper swings freely.
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
B1.
Read the instructions on the REAR WALL TEMPLATE.
Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall plate.
Cut the opening, following the instructions of the REAR
WALL TEMPLATE.
3
2
1
You need to cut an opening in the rear wall for outside
exhaust.
Exhaust
Adaptor

GE JVM3162 Specifications

General

Brand	GE
Model	JVM3162
Category	Microwave Oven
Language	English