GE JVM3162 Installation Instructions

16
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
B4.
•
Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when
drilling holes in the cabinet bottom.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt End
Installation Instructions
You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through.
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
CAUTION: Be careful to avoid
pinching fingers between the back of the
mounting plate and the wall.
Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
3
4
ATTACH THE MOUNTING PLATE
TO THE WALL
B3.
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
toggle wings to
3
/4” onto each bolt.
1
2

GE JVM3162 Specifications

General

Brand	GE
Model	JVM3162
Category	Microwave Oven
Language	English