3
WHEN REPLACING THE
CHARCOAL FILTER
C5.
MOUNT THE OVEN
(continued)
C4.
Slide the old filter down and out to remove it.
Remove plastic and other outer wrapping from the
new filter and install the new filter. When properly
installed, the wire mesh of the filter should be visible
from the front.
Replace the grille and the 2 screws.
Close the door.
22
If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to
12 months, depending on hood usage). See your
Owner’s Manual for the filter kit number.
To replace the charcoal filter:
Open the microwave door.
Remove 2 screws from the top of the grille. (You may
need to open the cabinet doors to remove the screws.
Slide the grille to the left and forward to remove.
Installation Instructions
5
4
Tighten the two screws to the top of the oven
completely. (While tightening screws, hold
the oven in place against the wall and the top
cabinet.)
Attach the oven to the top cabinet by inserting
2 self-aligning screws through outer top cabinet
holes. Turn two full turns on each screw. Be sure
to keep power cord tight. Be careful not to pinch
the cord, especially when mounting flush to
bottom of cabinet.
Install grease filters. See the Owner’s Manual
packed with the oven.
5
Insert filter mesh-side up
Charcoal
Filter
6
4
7
3
2
1
To Next Page
Loading...
Need help?
General
