GE HEALTHCARE LOGIQ F SERIES
DIRECTION 5446617-100, REVISION 10 BASIC SERVICE MANUAL
7 - 4 Section 7-3 - Screen Captures
Section 7-3
Screen Captures
There may be times when the customer or field engineer will want to capture a presentation on the
screen. This is accomplished by first saving the image(s) to the clipboard using a Print Key.
7-3-1 Check and Record the Store Key Function
Check the function of the Print Key in the event that the customer may have made some custom
settings.
1.) Enter Utility -> Connectivity -> Buttons.
2.) In the Physical Print Buttons field, select Print1, Print2 or Print3.
The Connectivity/Buttons Screen will be displayed like the one shown in Figure 7-2 on page 7-4.
If Print key is not set to Whole Screen, as shown in Figure 7-2, proceed to step 5 to record the
customer’s customized settings.
3.) In the Destinations section, record the service that is displayed.
4.) In the Physical Print Buttons section, record the parameters related to the service.
7-3-2 Setting the Print Key to Screen Capture
If the Print Key is not set to screen capture:
1.) While on the Connect screen, with the Buttons tab displayed, go to the Destinations list.
2.) From the list select Copy To Dataflow. Press [>>] to add the selection to the Printflow View
section.
3.) Ensure that the Physical Print Buttons section for capture Area is set to Whole Screen,
secondary Capture and No Image Compression.
4.) The Store Key should now be set up for whole screen capture, sending the screens to the
image buffer (clipboard).
7-3-3 Capturing a Screen
The following is a generic process to capture any screen from the scanner:
1.) Navigate to and display the image/screen to be captured.
2.) Press Print. This will place a snapshot of the screen on the “clipboard” displayed at the bottom
of the scan image display.
Figure 7-2 Set print Key
To Next Page
Loading...
Need help?
General
