Page 19
Beeps for 1 second or emits a “ding-dong” sound for the “Chime”
feature.
Beeps during an exit delay; beeps rapidly for the last 10 seconds of an
exit delay; and beeps 1 second at the end of the exit delay.
Pulses when the armed status changes and the AC power is off.
Pulses when the armed status changes and any zone(s) are bypassed.
Pulses when the armed status changes and a low battery is detected.
Pulses when the armed status changes and a Tamper condition is
detected.
Beeps to indicate Telephone Line Cut, if selected.
Pulses when one or more of the following conditions are detected: Zone
or Box Tamper, Low Battery, AC Power Fail, or Expander trouble.
Entering a valid code will silence the keypad sounder when it is pulsing.
The arm/disarm state of your system will not change when entering a code
to silence a pulsing keypad sounder. Please contact your installer if a
trouble condition exists.
EMERGENCY EVACUATION PLANS
An emergency evacuation plan should be established for an actual fire alarm
condition. For example, the following steps are recommended by the
National Fire Protection Association and can be used as a guide in
establishing an evacuation plan for your building.
Draw up a floor plan of your home. Show windows, doors, stairs, and
rooftops that can be used for escape. Indicate each occupant's escape
routes. Always keep these routes free from obstruction. Determine two
means of escape from each room. One will be the normal exit from the
building. The other may be a window that opens easily. An escape ladder
may have to be located near the window if there is a long drop to the
ground below. Set a meeting place outdoors for a headcount of the building
occupants.
Practice escape procedures. In a home, sleep with bedroom door closed;
this will increase your escape time. If you suspect fire, test the door for
heat. If you think it is safe, brace your shoulder against the door and open
it cautiously. Be ready to slam the door if smoke or heat rush in. Practice
escaping to the outdoors and meeting in an assigned spot. Call the Fire
Department from a neighbor's phone. NOTE
: After the installation of your
Security System has been completed, notify your local Fire and Police
Departments to give them your name and address for their records. Early
To Next Page
Loading...
Need help?
General