Page 7
EMERGENCY ACTIVATION KEYS
NOTES: You must hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activation
keys (see page 1). You should press these keys only in an emergency
situation that requires response by emergency personnel. If your system is
programmed for these functions, the following reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two
seconds. If your system is connected to a monitoring center, an emergency
report could be sent to that center.
Auxiliary Emergency Key – This key can activate the auxiliary alarm
when pressed for two seconds. If your system is connected to a monitoring
center, an emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm
when pressed for two seconds. If your system is connected to a monitoring
center, an emergency report could be transmitted to that center. NOTE:
Some Panic/Hold-Up alarms are programmed to be silent at the protected
site while reporting an alarm to the monitoring center. Check with your
installing company to determine how your security system will respond to
the Panic/Hold-Up activation.
KEYPAD FUNCTIONS
ARMING YOUR SYSTEM IN THE “AWAY” MODE
AWAY is used when the user is away from the premise and wants the
interior protected. Listed below are the steps to arm in the AWAY Mode:
Close all protected doors and windows. Step 1
• Ready light will be on or flashing when all protected zones and
sensors are secure. NOTE
: If any zones are bypassed, a senso
in that zone can be violated without affecting the ready light.
• The security system will not arm if the ready light is not on o
flashing.
• If the power light is off, you have no AC power. Restore power i
possible. If not, contact your installing company listed on page 1
of this booklet for service.
To Next Page
Loading...
Need help?
General