LCD KEYPAD 7
Table 3-4 AMERICAN SPANISH LIBRARY
ABAJO CONTACTO EXTERIOR JARDIN PRINCIPAL SOTANO
ALARMA CRISTAL FACHADA LABORATORIO PUERTA TALLER
ALMACEN DESPACHO FUEGO LATERAL RECEPCION TECHO
ARRIBA DETECTOR GARAJE LAVABO RECIBIDOR TERRAZA
AVERIA DISPARO GERENCIA MAGNETICO SABOTAJE TIENDA
AZOTEA DOBLE TECHNOLOGIA GOLPE OFICINA SALA TRASERO
BARRERA DORMITORIO HABITACION PANICO SALIDA VALLA
CAJA FUERTE EMERGENCIA HUMO PARED SALON VENTANA
CLARABOYA ENTRADA INFORMATICA PASILLO SENSOR VESTIBULO
COCINA ESTACIONAMIENTO INFRARROJO PERSIANA SILENCIOSA ZONA
COMEDOR ESTUDIO INTERIOR PLANTA SIRENA
4. LOADING FACTORY DEFAULTS
ACTION RESULT
Follow procedures on page 4 (Sections 1 and 2) and enter the Program Mode for the module to default.
#
Keypad will beep 3 times (loading is in progress).
The loading takes about 6 seconds.
To load the factory defaults for the LCD keypad,
enter the Program Mode from a different keypad
(does not have to be LCD keypad), and follow the
same procedures.
The two-line Custom and two-line Shutdown Messages will not be defaulted.
5. ENROLLING
For supervision purposes, the NetworX control panel has the ability to automatically find and store in its
memory the presence of all keypads, zone expanders, wireless receivers, and any other module
connected to the data terminal. This allows these modules to be supervised by the control panel. NOTE:
All modules should be connected and set to unique addresses prior to enrolling modules. To enroll the
modules, enter the Program Mode of the NetworX control panel. When the Program Mode is exited, the
control will enroll the devices. The enrolling process takes about 12 seconds, during which time the
"Service Required" will be displayed. Once a module is enrolled, if it is not detected by the control, the
"Service Required@ will be displayed.
To Next Page
Loading...
Need help?
General