GE PD968SPSS User Manual

8
InstallationInstructions
INSTALL STOP SCREW
Thesescrewspreventtherangefromslidingoutof
positionduringoperation.
1.Carefullymarkthecabinetforthelocationofthe
stopscrews.
2.Drill1/8”pilotholesintocabinet,oneachsideof
therange.(Donotdrillentirelythroughthecabinet
wall.)
3.Carefullyturntheshoulderscrewsintothepilot
holesuntiltheyaretight.
PLACING RANGE INTO THE OPENING
1.Itisrecommendedthattwopeoplelifttherange
intoplace,carefullysettingthesidemetalflanges
undertheglassontheedgesofthecountertop
opening.
2.Carefullyslidetherangetowardthebackofthe
opening.Stoppushingtherangewhenthereistill
a4”gapatthefrontbeforeflushingtherangewith
thecounter.
REMOVE THE PROTECTIVE CHANNELS (if provided)
Carefullyremovetheprotectivechannelsfromthe
sidesoftheglasscooktop.Thismayrequireaslight
liftingoftherangetoremovetheweightoftherange
fromtheprotectivechannels.
CHECK ANTI-TIP BRACKET
Withtherangestillsittingoutfromthecounter-top,
confirmtheanti-tipbracketissecurelyattachedto
therearoftherange,andslidetherangebacksothat
theanti-tipbracketslidesjustunderthecountertopor
woodblockattachedtotherearwall.
Iftherangeispulledfromthewallforanyreason,
alwaysrepeatthisproceduretoverifytherangeis
properlysecuredbytheanti-tipbracket.
7

INSTALL THE RANGE
GapApprox.4”
GapApprox.4”
GlassCooktop
ProtectiveCover
Remove Protective Cover from Both Sides after Range is in Cabinet
Countertop
Oven
Anti-Tip Bracket
Countertop or
Wood Block

GE PD968SPSS Specifications

General

Brand	GE
Model	PD968SPSS
Category	Ranges
Language	English