Instructions d’installation
Installation
Instructions
Microwave Oven
Series
PEB3228
Questions? Call 1-800-561-3344 or visit our Website at: GE Appliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully
•
IMPORTANT – Save these instructions for
local inspector’s use.
•
IMPORTANT – Observe all governing
codes and ordinances.
•
Note to Installer – Be sure to leave these
instructions with the Consumer.
•
Note to Consumer
– Keep these instructions for
the future reference.
•
Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Installation time – 1 - 3 hours
• The installer is responsible for the quality of the
installation.
• Product failure due to improper installation is not
covered under the Warranty.
• This set is CUL approved for installation alone or in
combination with a single GE or GE profile electric
built-in oven.
•
• For easiler installation and your own safety, we recom
-mend that the installation of this microwave oven
be done by two people.
• Unplug the microwave oven before beginning insta
-llation of this set.
WARNING – This oven must be connected to
a properly grounded three-pronged 120V outlet, as
required by the National Electrical Code.
PARTS INCLUDED
PART QUANTITY
1
Bottom duct
1
Rails 2
Trim kit
frame
1
Inlaid
Short screws
14
(11
+ 3
extra)
6
–
painted
(4
+ 2 extra)
NOTE
: This set includes extra screws to prevent
technician from wasting time looking for a
replacement screw if he lost one of them during
the installation.
For your safety
WARNING –
Before starting the installation, switch
off the power at the distrubition board and block the circuit
breaker to prevent the power from being accidentally reset.
If it is not possible to block the circuit breaker, put a warning
clearly visible, as a label on the switch board.
Long wood
screws
Finishing sets for built-in
Do not alter or modify any parts of this set or any
parts of the oven.
?
To Next Page
Need help?
General
