GE SENOGRAPHE DMR+ User Manual

    
  
)
 %
 
2–1 Electrical Specification
The Senographe DMR is a class I type B equipment.
2–1–1 Line voltage specifications
D Single–phase input voltage:
* :::):0:) D <L  M=
2 "-, ("
D 50 or 60 Hz (1 Hz)
2–1–2 kVA load characteristics
D 8.5 kVA for exposures up to 4.5 s.
7.5 kVA during 10 s
D Power factor: 0.61.
D The maximum line current corresponds to the use of the technique factors 30 kV, Mo
track, large focal spot, and at least 100 mAs.
2–1–3 Input impedance
Line impedance at maximum workload 3.5%.
Line impedances under single–phase installation:
* 4
1
I    <= " ! 
* 4
1
0 I   -  4   0D <( #=
* 3 I  ( #
R
I
380 = R
I
x (380/U)
2
* ,( $ 4
1
0 v  W  /  I  ;D5
Note: The optional STEREOTIX 2 is supplied through the SENOGRAPHE DMR gantry
(Nominal voltage = 27 V).
2–1–4 Generator Output (excluding tube)
D 22 thru 49 kV,
D 20 thru 130 mA.
2–1–5 Duty Cycle
The generator is always limited by the tube:
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

GE SENOGRAPHE DMR+ Specifications

General

Brand	GE
Model	SENOGRAPHE DMR+
Category	Medical Equipment
Language	English