Simon XT
User Manual
18
Keyfob
If your installer programmed the keyfob with no entry delay, and you armed the system with the keyfob, you
must disarm your system before entering the home to avoid causing an alarm.
Figure 4. Keyfob (keychain touchpad)
Note: For any key press on the keyfob, hold the button until the indicator light blinks
If your installer programmed your system for remote touchpad arming, you must enter your home to start the
entry delay before you can use your keyfob to disarm the system.
Note: Panic alarms need to be silenced from the panel, a remote handheld touchpad, or another keyfob. They cannot be
silenced from the same keyfob that activated the alarm.
CAUTION: To avoid causing false alarms, check with your installer on how your touchpad options are programmed.
Lock Press once to arm doors and windows.
–
Lock Press twice to arm doors, windows, and motion sensors.
– –
Lock Press three times to arm doors, windows, motion sensors, and to activate the latchkey
option.
+
Lock and
unlock
Press both buttons simultaneously for three seconds to send a panic (intrusion, silent, or
nonmedical emergency) alarm to the central monitoring station. Check with the installer
to find out how the keyfob panic buttons will operate.
Unlock Press to disarm your security system.
Star Can be programmed to control a device connected to a universal module.
Light Can be programmed to control a device connected to a lamp module. Press once to turn
on all lights on lamp module. Press again to turn off all lights on lamp module turn off.
o
ot
for 3 sec.
To Next Page
Need help?
General
