Gemini 933 Series User Manual

To carry out the operation successfully, make sure the required electrical connections
(bonnet push-button and positive under key) are complete.
All device previously programmed in the memory can be erased.
To clear memory proceed as follows.
With system disarmed, open the bonnet and leave it open! .
!
!
!
!
Turn ignition key “ON-OFF”-“ON-OFF-ON”-“OFF-ON”.
After the fourth rotation, leave it “ON”.
.
Close the bonnet.
.
To confirm it has entered in the delete mode, the system gives two acoustic signals (one high and
one low-pitched), the turn indicators flash once and the LED turns ON
To clear the memory, leave the bonnet closed for at least 8 seconds
!
The following operations must be carried out within four seconds otherwise the
procedure is invalidated.
If the bonnet is opened before 8 seconds, the devices will not be
deleted.
!
!
.
”.
The status LED turns OFF when the devices are deleted
Turn ignition key “OFF
The end of the procedure is indicated by one long low-pitched acoustic signal.
!
14.0 - DELETING PROGRAMMED DEVICES
To carry out the operation successfully, make sure the required electrical connections
(bonnet push-button and positive under key) are complete.
To activate the procedure proceed as follows:
With system disarmed, open the bonnet and leave it open! .
!
!
!
Turn ignition key “ON-OFF”-“ON-OFF”-“ON-OFF”-“ON”.
At the fourth rotation, leave it “ON”.
.
To confirm it has entered in the self-learning mode, the system gives two acoustic signals (one high
and one low-pitched), the turn indicators flash once and the LED turns ON
The following operations must be carried out within four seconds otherwise the
procedure is invalidated.
Do not close the bonnet otherwise all previously programmed devices are erased as
described in the next paragraph.
!
!
!
!
!
The system is ready to receive the device codes.
;
R
“OFF”.
T
Touch the electronic key to the receptacle each time a device is learned a high-pitched signal
sounds and the status LED turns OFF briefly.
epeat this procedure to program other devices.
Turn ignition key
o confirm the end of the procedure, a low-pitched signal sounds, the turn indicators flash once and
the status LED turns OFF.
13.0 - ADDING NEW DEVICES
PAGE 14 - INSTALLER MANUAL INSTALLER MANUAL - PAGE 15
Storing memory is for 55 devices
If an extra device is added, it automatically deletes the first device programmed in the
system memory.
.
!
!
!
!
!
!
!

Gemini 933 Series Specifications

General

Brand	Gemini
Model	933 Series
Category	Security System
Language	English